Battery initial installation

What are the initial charging procedures for batteries?

The initial charging procedures for batteries are a crucial step in preparing them for service. These procedures vary depending on the type of battery cells, such as lead-antimony and lead-calcium batteries. Let’s delve into the details of these initial charging processes: Wet Cells and Periodic Monitoring

How do you replace a battery?

Secure the new battery to the bracket and grease the terminals. Place the new battery in the battery tray and secure it to the bracket. Simply reverse the process you used to remove the battery from the bracket. Then, coat each of the terminals in a thin layer of lithium grease to prevent corrosion.

Where should batteries be installed?

If no shipping damage after checking, install the batteries in the designated position; When installing batteries in a cabinet or on a rack, start at bottom & finish with placement at the top.

Do I need a supplementary charge before installing a battery?

Measure the battery open circuit terminal voltage which should be > 2.1 volts/cell (12.6 volts for a 6 cell battery). If any batteries are lower they will need a supplementary charge prior to installation. To ensure maximum service life a supplementary charge may be required prior to installation. Apply a supplementary charge if:

How do I assemble a battery rack/enclosure?

To assemble a battery rack/enclosure, please see rack installation instructions. Connect battery modules together to the required system voltage, then connect battery string with charger or load; When multi-strings of batteries are to be parallel connected, connect batteries in series first and then complete the parallel connection.

How to check the state of charge of a battery?

It is essential to periodically monitor the state-of-charge of wet cells by measuring the specific gravity. If there is a 25 point (0.025) decrease in specific gravity, a freshening charge should be applied to maintain the battery’s performance.